Full Dip Kingsley Blue Matte Aerosol

Full Dip kingsley Blue Matte Can change the colour of your Car, motorbike, alloy wheels, badges, emblems, grilles and interior Trim.
Use around the Home or Garden, arts & crafts. You can full dip almost anything.
Recommended base colour Grey / Nardo grey

1. SURFACE PREPARATION
Before you start spraying the liquid vinyl, you need to have the surface completely clean, dry and free of any substance that may be capable of causing non grip (as waxes, cleaners etc). It is advisable to ensure that the surface is clean as possible without dirt (such as sand , dust, road tar, brake dust etc.) Full Dip® will bond to the surface you spray it on, and thus, if the surface is not 100% clean, you will get imperfections and faults.
So it is important you clean properly (even those annoying parts and between spokes on wheels). Cleaned perfectly and you will get uniform even finish that lasts years.

Before Application

1.2 TOLERANCE TEST
Full Dip® can be applied to any surface such as metals, plastics, glass, wood, etc.. However it may best to do a small pre-test on an insignificant part of your project before committing to the full project to make sure it is 100% compatible to what you are spraying over with no adverse reaction.

2. APPLICATION OF Full Dip®

2.1 SHAKE IT
Shake vigorously before use. At least a minute to mix all the internal elements.

2.2 SPRAY IT
We recommend 100% using a proper PPE mask during application.

First apply tack Coats

Lightly spray one or two tack (dusting) coats allowing at least ten minutes drying time between coats. You are now ready to spray normal wet coats.Apply the product approx. 20 cm range. Always parallel to the surface you are spraying. You can apply as many coats as you want, keeping in mind that you will need an average of 4-6 coats. But remember, that more coats you apply, the more durable it will be. The result will be better and more easily peeled if you want to remove in the future. Use less coats, two or three, then expect problems like hard to remove,poor finish and durability. Between coats, you must wait at minimum 10-30 minutes. Full dip will be touch dry in 10-30 minutes, but to be completely dry you need wait 12 hours. Once dried / cured, your project is ready to use.

You can clean Full dip with most soaps, and it will resist water, mud or pressure water cleaning.
No cracks or self peeling over time, remains flexible and stretchy, and will not become brittle or crack.
Check out our dip Care Products and keep your Fulldip in great condition and looking great.

Full Dip matte range

Will wrap, protect and change the colour of your project with a matte finish. You can add glossifier, metalizer or high gloss top coat if desired.
It can be removed by peeling it, as if it were a conventional vinyl.
Long research and development process from pioneers in the liquid vinyl spray for quality products.

Properties

Full Dip 400ml spray covers up to 1.2 meters sq.
Air dried, flexible, liquid coating for use on almost anything
Liquid Vinyl spray application, once dry becomes a tough elastic and durable film.
It can be easily removed from most surfaces if required,Plastic,glass and metal.
You will need an average of 4-6 coats. Add more layers for greater protection. Sprayable Liquid Wrap in a Can.

Instructions for use on full dip kingsley blue matte, please go to our application Guide.